27 5 月 2024

How To Adjust Beneficiation Shaker

The adjustment of beneficiation shaker mainly includes the adjustment of stroke, stroke, transverse slope and longitudinal slope.

Stroke adjustment: The stroke is increased or decreased by turning the stroke handwheel clockwise or counterclockwise, the range of stroke variation is usually between 8 and 36 mm. When adjusting the stroke, the spring adjusting bolt at the back of the transmission box must be adjusted accordingly at the same time to maintain the appropriate degree of tightness and avoid damage to the parts due to too loose or too tight spring.

Adjustment of the stroke: adjust the stroke by replacing the motor pulley, the larger the diameter of the motor pulley, the larger the stroke, and the smaller the vice versa.

Adjustment of transverse slope: turn the hand wheel of slope adjustment on the slope adjuster (machine foot) to fine tune, and when the hand wheel turns clockwise, the bed surface will rise to the mine end; When the hand wheel turns counterclockwise, the feed end of the bed surface drops.

Adjustment of longitudinal slope: Adjustment is made on the support box of the slope adjuster (machine foot), and the longitudinal slope of the bed surface is adjusted by turning the screw on the side of the connecting box. After the slope is determined, tighten the fixing bolts of the channel steel feet.

In addition, the installation and commissioning of the beneficiation shaker also need to pay attention to the following points:

Before installation, thoroughly check and pre-bury the anchor screws to ensure that the parts of the beneficiation shaking table are complete and the appearance is without loss.

During installation, ensure that the installation center of the bed is consistent with the center of the headboard connector, and ensure that the holes of the connecting screws on the bed are aligned.

After installation, the two small time and space load debugging operation is carried out to check whether the motor is working normally, the contact of each part and the wear of the friction joint, whether there is abnormal noise, whether the lubrication is normal, and whether the horizontal slope adjustment is flexible and smooth.

Through the above steps, the accurate adjustment and efficient operation of the beneficiation shaker can be ensured.

发表回复

您的电子邮箱地址不会被公开。 必填项已用 * 标注