lab round disc crusher

Lab Round Disc Crusher

Product introduction

The laboratory disc crusher is mainly to facilitate enterprises or scientific research units to conduct experimental extraction of minerals before mining, and to determine the value of minerals and mining work. The disc pulverizer is mainly composed of the body, the base, the main shaft, the movable grinding disc, the fixed grinding disc, the end cover, the upper cover and the hopper. The body is installed on the base; its transmission part consists of a main shaft, a bearing, a moving grinding disc and a pulley; the working chamber is composed of an end cover, an adjusting shaft, a fixed grinding disc, a moving grinding disc and a feeding port. When the disc crusher is working, the motor transmits the power to the transmission part through the V-belt, so that the movable grinding disc and the fixed grinding disc move relative to each other, thereby crushing the incoming materials. The material is pulverized in the working room. The material enters the hopper from the feeding port above the end cover, and enters the middle of the two grinding discs through the feeding port. Due to extrusion and grinding, the sample is crushed. It flows out and falls into the hopper below.

lab round disc crusher-1
lab round disc crusher-2
lab round disc crusher-3

Product application

Application areas: laboratories or laboratories in metallurgy, geology, mining, building materials, chemical industry, etc.

Equipment advantages: The laboratory disc crusher has good sealing performance, convenient cleaning, high hardness, small volume, light weight, low pollution, and is simple and fast to use.

working principle:

This machine is mainly composed of body, base, main shaft, movable grinding disc, fixed grinding disc, end cover and hopper, etc. The power is transmitted to the pulley through the V-belt to drive the main shaft to rotate, so that the movable grinding disc and the fixed grinding disc move relatively, so that the sample is crushed. The particle size of the material can be controlled by adjusting the gap between the grinding discs through the large and small handwheels, the main shaft, etc.

The body is installed on the base, and its transmission part is composed of a drive shaft, a bearing, a moving grinding disc, a pulley, a studio end cover, an adjusting shaft, a fixed grinding disc, a hand wheel, and a feeding port.

The material is crushed in the working room. The material is fed from the feed port above the end cover and enters the middle of the two grinding discs. Due to the crushing effect of the test, the crushed sample flows out from the gap between the two grinding discs and falls into the hopper below. .

The grinding disc is made of strong and tough white iron treated with water toughness, which has good wear resistance.

The principle of the adjustment mechanism is to rotate the handwheel to make the adjustment shaft move forward or backward, thereby adjusting the gap between the two grinding discs and adjusting the particle size of the material.

Equipment model

Model

Capacity(Kg/h)

Disk dia(mm)

Feed size(mm)

Output size(mm)

Rotating speed(r/min)

Power(kw)

Weight(kg)

LZPF 175

10-30

175

4

0.18-0.074

980

1.1

100

LZPF 200

15-40

200

6

0.18-0.074

950

1.5

150

LZPF 250

25-50

250

8

0.18-0.074

800

2.2

170

LZPF300

40-80

300

10

0.18-0.074

800

4

195