WET PAN MILL

Wet Pan Mill

Product introduction

Gold rolling machine is also called wet rolling machine and wheel rolling machine. It is mainly used for equipment that is crushed after the material is crushed. It is widely used in cement, silicate products, new building materials, refractory materials, fertilizers, ferrous and non-ferrous metal beneficiation and glass ceramics and other production industries, dry or wet grinding of various ores and other grindable materials. All the minerals that can be selected by ball mills and gold mills can be used. In addition, the gold milling machine is easy to install and maintain, with small investment, high output, quick effect and low production cost.

wet pan mill-1
wet pan mill-2
wet pan mill-3

Product application

Application materials: Gold rolling machine is mainly used for gold, silver, lead, zinc, iron, molybdenum, copper, antimony and other ores. Advantages of equipment: Gold rolling machine mainly achieves moisture balance, uniform ratio, low air content through repeated stirring, rolling, crushing and rolling of raw materials, improving forming rate and forming quality, and forming the material rolled by this machine. The product has the characteristics of high density, good strength, and no porosity. High efficiency and energy saving, high output, this product is used for the recovery of tailings in the iron ore process, so that the ore powder is not lost, and the effective resources can be fully utilized. Work and maintenance: 1. Only after the mill runs normally, can start feeding. 2. The machine is forbidden to start with material. When it is stopped for some reason, the residual ore in the middle of the grinding tank must be cleaned up before starting. 3. The material should be evenly fed, and it should not be too much or too little. It is better to use a feeder. 4. The bearing part must be frequently added with butter, and the gear box or the rear axle of the car must be frequently checked for damage to the gear oil. 5. Always check whether the screws in each part are loose. 6. When the bearing is found to be damaged, it must be replaced in time to avoid damage to other parts due to shaft eccentricity 7. When the mill is running, pay attention to whether there is abnormal noise in the reducer or the bearing part, whether there is abnormal temperature rise, whether the motor current is too large, etc.; 8. When overhauling the machine, in order to ensure safety, the motor belt must be removed.

 

Equipment model

Model

Specification

Input size

capacity

Rotate Speed 

Powder

LZ1600

1600×400×200×500±20mm

<30 mm

1300kg/h

20-22 r/min

30kw

LZ1500

1500×350×200×460±20mm

1100kg/h

20-22 r/min

22kw

LZ1400

1400×250×150×350±20mm

900kg/h

16-18 r/min

18.5kw

LZ1200

1200×220×80×270±20mm

<25 mm

700kg/h

17-19 r/min

7.5kw

LZ1100

1100×200×80×250±20mm

500kg/h

23-25 r/min

7.5kw

LZ1000

1000×200×80×250±20mm

400kg/h

13-15 r/min

5.5kw

LZ900

  900×200×80×230±20mm

300kg/h

10-13r/min

3kw