Wet Pan Mill Installation and Maintenance
The maintenance and maintenance of the machine is an extremely important regular work, which should be closely cooperated with the operation and maintenance of the machine, and should be checked by full-time personnel on duty.
Installation commissioning
1. The wet mill should be installed on a horizontal concrete basis, and thin leather or square wood should be laid between the frame and the ground to play a shock absorption role. Special attention should be paid to not fixing the frame on the ground with foot bolts!
2, the installation should pay attention to the level of the main body and the ground, to the center of the frame spindle to correct the basin and roll the bottom!
3. After installation, check whether the bolts in each part are loose. If so, please tighten them.
4. Power line and control switch are configured according to the power of the equipment.
5, check, add a small amount of ore test, test half an hour after strengthening the bolts on the equipment, so repeated two or three times can be normal production!
Maintenance of machine
1. Bearing bears all the load of the machine, so good lubrication has a great relationship to the bearing life, which directly affects the service life and operation rate of the machine, so the lubricating oil injected must be clean, the seal must be good, the main oiling place of the machine
(1) upper bearing of reducer
(2) roller core bearing
(3) bearing on the main shaft
(4) add half of the clean gear oil to the gearbox
2. The fastening bolts of the newly installed roller outer ring and inner core are prone to loosening and must be inspected frequently.
3. Pay attention to whether all parts of the machine work normally.
4, pay attention to check the wear degree of easy to wear parts, pay attention to replace the worn parts at any time.
5. The bottom plane of the equipment should be removed from dust so as not to affect the operation of the motor and gearbox, resulting in serious accidents.
6. If the bearing has abnormal sound or the bearing position temperature rises, it should be stopped immediately to check the cause to eliminate.
7. If there is any abnormal response in the running of the rotating gear, stop immediately and check, and eliminate it.